Horizontal shades of blue lines
Resources

  • Application Notes
  • Reference Data
  • Articles
  • Brochures
  • Archives
Document Name PDF
The effect of contour concentricity on the acceleration sensitivity of quartz crystal resonators
Coefficient Corrected Oscillator Application Note
RF Handling of SAW Devices
Operating Guidelines for the TX-801 family of TCXOs
Environmental Influences on Short Term Stability Whitepaper
How To Choose An Oscillator To Support 1588 Timing Applications
Oscillator Short Term Stability and Allan Deviation
The Influence of Oscillator Behavior on Accumulated Phase Error during Dynamic Environmental Conditions
Enhanced Clock Stability for the 1588 enabled network
High Temperature Oscillator Characterization in Harsh Environments
Signal Types and Terminations
Holdover Oscillators Application Note
Simplifying Holdover Design in Synchronization Applications
Definition of Absolute Pull Range
Jitter in Clock Sources
Oven Controlled Crystal Oscillators
Voltage Controlled Crystal Oscillators
Phase Noise
Oscillator Glossary
Clock Oscillators
Crystal Glossary
Tutorial on Aging and Retrace
Tutorial on TCXO's (Temperature Compensated Crystal Oscillator)
CD-700 SYNCE Reference Design
Document Name PDF
Typical Phase Noise Performance for the VS-705 Series
Typical Jitter and Phase Noise Performance for the VC-710 series
Typical Phase Noise Performance for the VC-800 series
Typical Phase Noise Performance for the V-Type series
Typical Phase Noise Performance for the VCC1 series
Typical Phase Noise and Jitter Performance for the VCC4 series
Typical Phase Noise Performance for the VCC6 series
Typical Phase Noise Performance for the VTC4 series
Typical Phase Noise and Jitter Performance for the VVC1 and VVC2 series
Date Article Title PDF
2012 "The influence of oscillator behavior on accumulated phase error during dynamic environmental conditions,"Frequency Control Symposium (FCS), 2012 IEEE International , vol., no., pp.1–6, 21–24 May 2012 doi: 10.1109/FCS.2012.6243616Wacker, Mike F.; Matthews, Peter;  
2010 "Examining peculiarities of crystal oscillators using computer simulation,"Frequency Control Symposium (FCS), 2010 IEEE International , vol., no., pp.425-430, 1-4 June 2010Wacker, M.F.;  
2009 "The impact of tuning circuit configuration on the start-up time of crystal oscillators,"Frequency Control Symposium, 2009 Joint with the 22nd European Frequency and Time forum. IEEE International , vol., no., pp.956-961, 20-24 April 2009 doi: 10.1109/FREQ.2009.5168330Wacker, M.F.;  
2008 Electrically isolated thickness shear mode liquid phase sensor for high pressure environments, Andle, J.; Haskell, R.; Chap, M.; IEEE Ultrasonics Symposium  
2008 Quasi-2D COM model for diffraction calculation in slanted finger SAW devices, Chilla, E.; Steiner, B.; Grunwald, R.; Osetrov, A.V.; Hodkin, A.G.; Jaffer, A.; IEEE Ultrasonics Symposium  
2008 Acceleration sensitivity measurements of Quad Relief Mount langasite resonators, Haskell, R.B.; Buchanan, J.E.; Desai, B.B.; Stevens, D.S.; Yoonkee Kim; IEEE Frequency Control Symposium  
2008 Improvements in OCXO performance by the use of an on-board microprocessor, Wacker, M.F.; Villella, A.; IEEE Frequency Control Symposium  
2008 High sensitivity quartz cantilever gas sensors, Haskell, R.B.; Stevens, D.S.; Andle, J.C.; Chap, M.; IEEE Frequency Control Symposium  
2007 Obtaining Quartz Crystal Frequencies From Deterministic Temperatures and Random Angle Variations, David Chandler, Jeffrey Garstecki and Aldo Morales IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, Vol. 54, No. 7, pp. 1475-1481, July 2007  
2007 Design, Packaging and Characterization of a Two-Port Bulk Wave Langasite Viscometer, Andle, J.; Haskell, R.; Sbardella, R.; Morehead, G.; Chap, M.; Columbus, J.; Stevens, D.; Sensors, 2007 IEEE  
2004 State-of-the-art in the design and manufacture of Low Acceleration Sensitivity Resonators. R. Haskell, J. Buchanan, P. Morley, D. Desai, M. Esmiol, M. Martin, and D. Stevens
2004 Packaging Design & Manufacture of High Temperature Electronics Module for 225C Applications utilizing Hybrid Microelectronics Technology by Jacob M. Li
2003 Acoustic waves measurements on SNGS crystals and determination of material constants, Chilla, E.; Kunze, R.; Weihnacht, M.; Bohm, J.; Heimann, R.B.; Hengst, M.; Straube, U.; Ultrasonics, 2003 IEEE Symposium on  
2002 High Q, precision SC cut resonators with low acceleration sensitivity Technical paper by P. Morley, R. Haskell and D. Stevens
2002 Method for measurement of the sensitivity of crystal resonators to repetitive stimuli Technical paper by P. Morley and R. Haskell
2002 Investigation of acoustomigration effects in Al-based metallizations, Schmidt, H.; Kunze, R.; Weihnacht, M.; Menzel, S.; Ultrasonics Symposium, Proceedings. 2002 IEEE  
2002 Embedded inductors incorporated in the design of SAW module SMT packaging, Potter, B.R.; Mink, J.; Narayanan, V.; Ultrasonics Symposium, Proceedings. 2002 IEEE  
2002 Design of SPUDT filters on quartz considering waveguide modes, Steiner, B.; Martin, G.; Ultrasonics Symposium, Proceedings. 2002 IEEE  
2001 Transversal SAW filters using a BDT and a SPUDT, Jaffer, A.; Steiner, B.; Renger, J.; Dong-Pei Chen; Lam, C.S.; Ultrasonics Symposium, 2001 IEEE  
2001 Optimising slanted-finger interdigital transducer (SFIT) filters, Steiner, B.; Ultrasonics Symposium, 2001 IEEE  
2001 Investigation of SAW-induced acoustomigration effects in Cu- and Al-based metallizations, Schmidt, H.; Menzel, S.; Weihnacht, M.; Kunze, R.; Ultrasonics Symposium, 2001 IEEE  
2000 Low noise, low jitter hybrid ovenized SAW oscillators, Adler, J.V.; Clark, R.L.; Chen, D.P.; Ultrasonics Symposium, 2000 IEEE  
1999 Improved aging results using thick-film hybrid packaging and evacuated miniature ovenized oscillators using such packaging, Clark, R.L.; Li, J.; Adler, J.; Frequency and Time Forum, 1999 and the IEEE International Frequency Control Symposium, 1999.,  
1999 Theoretical and experimental results for the acceleration sensitivity of rectangular crystal resonators, Stewart, J.T.; Morley, P.; Stevens, D.S.; Frequency and Time Forum, 1999 and the IEEE International Frequency Control Symposium, 1999.,  
1998 Design optimization for acceleration sensitivity, Stewart, J.T.; Stevens, D.S.; Frequency Control Symposium, Proceedings 1998  
1997 Three dimensional finite element modeling of quartz crystal strip resonators, Stewart, J.T.; Stevens, D.S.; Frequency Control Symposium, Proceedings 1997  
1997 Analysis of the effects of mounting stresses on the resonant frequency of crystal resonators, Stewart, J.T.; Stevens, D.S.; Frequency Control Symposium, Proceedings 1997  
1997 Finite element modeling of the effects of mounting stresses on the frequency temperature behavior of surface acoustic wave devices, Stewart, J.T.; Chen, D.P.; Ultrasonics Symposium, Proceedings, 1997  
1997 Design considerations of vacuum-sealed OCXO's for HI–REL applications, Clark, R.L.; Scalpi, A.; Frequency Control Symposium, Proceedings 1996  
Brochure Title PDF
Precision Frequency Control and Timing Solutions (Our Standard Product Overview Brochure)
Military Products
Space Products, Hi-Reliability
Saw Fillter Products
High Temperature Electronics
Timing Modules
CD-700 A Quartz Stabilized PLL
Archived Title PDF
Reducing Power Consumption on LVPECL XO, VCXO's
EX-380/385 Series (EMXOTM) Application Note
Evacuated Miniature Crystal Oscillators
SAW-Based Frequency Control Product Applications
Clock and Data Recovery Products  
Comparing Vectron's Crystal-Based PECL Oscillator with a SAW-Based Equivalent
A Comparison of 125MHz CMOS Oscillators: Crystal Versus SAW Technology
CD-700/TRU-050 Code Mark Inversion (CMI) Input Data